Mac Built-in Audio Ports, Problem with audio ports Options

[mfro]

hi

this is probably a dumb and somewhat obsolete question but nonetheless:

I've been recording into my BW G3 into Pro Tools Free through the built-in sound input which works fine except that I have to pull the jack halfway out (to the ring I suppose) to get the full signal or, in some cases, a stereo signal. If it's in all the way I only get a partial signal that sounds like half of the audio is cut out. I've spent hours of internet searching but haven't been able to dig up much info, other than it may have something to do with Apples' plaintalk technology. I'm using 1/8" to 1/8" cables from radio shack with a 1/8" to 1/4" adapter on one end to go into my mixing board.Since the jack is practically hanging out of the input the tiniest bump or pull disengages the signal making it really hard to get anything done. I tried the griffin imic as a solution but couldn't get it to work properly with Pro Tools free.

Anyone know what is going on?

thanks much
mfro

[kaboombahchuck]

Hi mfro
Sounds like you have one of 2 problems:

1 You are actually plugging into the mic in and not audio in (sometimes the simplest of mistakes cause the largest problems)

2 The plug is diffective on the mac.

Next time you are checking it out, see if when you pan on the mixing board, the sound goes side to side on the sound out of the mac. If not then you are recording in mono. This means the plug is diffective.

At any rate, sounds like a good excuse to get a new sound card.