  |
 M-audio Fw 410 - Positive Reviews?? Anyone??, FW 410 or MKII....no contest?? |
  lun. 15 déc. 2003, 01:32
Message
#11
|
|
 Moderator In Chief (MIC)  Groupe : Editors Messages : 15,189 Inscrit : 23 déc. 01 Lieu : Paris - FR Membre no 2,758  |
More expensive but balanced you have the Metric Halo Mobile I/O…
828 is cool  Also check the Tascam 1884 and Yamaha 01x, there a lot going in these too (mixers and control surface, effects) and they have already positive reviews here even if the drivers of the Tascam are still not full featured. I'm lazy so I don't have looked again how they handle balanced signal… do your homework 
-------------------- Our Classifeds • Nos petites annonces • Terms Of Service / Conditions d'Utilisation • Forum Rules / Règles des Forums • MacMusic.Org & SETI@Home
BOING BUMM TSCHAK PENG! Are you musician enough to write in our Wiki? BOING BUMM TSCHAK ZZZZZZZZZZZOING! Êtes-vous assez musicien pour écrire dans le Wiki? |
 |
 
|
|
lun. 15 déc. 2003, 01:33
Message
#12
|
|
 Junior Member  Groupe : Members Messages : 127 Inscrit : 22 août 03 Lieu : Greenwood - US Membre no 23,402 |
Presto
Anytime you see RCA style connectors, they are unbalanced. To have a balanced connection, you either have an XLR mic connector, or a tip/ring/sleeve style connetor (think headphones). If a cable only has a tip and a sleeve (think guitar cable) then it is unbalanced. Hope this helps Scott |
|
|
|
|
lun. 15 déc. 2003, 01:39
Message
#13
|
|
 Maniac Member Groupe : Members Messages : 799 Inscrit : 24 mars 02 Lieu : Entre-Deux-Mers - FR Membre no 3,984 |
Have a look at what I quoted. I thought they did say XLR. I'd better go back to school or buy some new glasses.
Ah I added the bit including XLR after (edit). You must have missed it. Anyway, nice advice from you Scott. Finally looked at the Egosystems site. The Quatafire does have two combo XLRs on the front. There's a pic 
Ce message a été modifié par Presto - lun. 15 déc. 2003, 02:22. -------------------- Without shit, we wouldn't be here ;)
|
|
|
|
|
1 utilisateur(s) sur ce sujet (1 invité(s) et 0 utilisateur(s) anonyme(s))
0 membre(s) :
