  |
 Help! Where Do I Plug My Headphones?, Problem with basic mixing |
 dim. 9 avril 2006, 15:19
Message
#1
|
|
 Newbie Groupe : Members Messages : 1 Inscrit : 09 avril 06 Lieu : Bristol - UK Membre no 79,005  |
I own a powerbook g4 and have recently downloaded some dj mixing software like dj1800, obelisk and tactile. However I have not been able to make a single mix as I'm not sure how to plug my headphones in alongside my speakers which use the headphone/line out socket. The other socket seems to be intended for speakers (it has a picture of a circle with two triangles coming out of it!?) but when i plug them into it the sound continues to come out of the built in ones.
Do I need a new driver so the other socket will recognise my speakers? Or perhaps a splitter so i can plug headphones and speakers into the same socket? Any help would be much appreciated! Cheers DAN |
 |
 
|
|
dim. 9 avril 2006, 20:42
Message
#2
|
|
 Maniac Member  Groupe : Members Messages : 899 Inscrit : 12 oct. 01 Lieu : Kirkland Membre no 2,002 |
That's a good question, I suggest that you read the manual for your speakers to determine the operation. I have many talents but being Physic is NOT one of them.
   
-------------------- G-Dub
|
|
|
|
|
dim. 9 avril 2006, 21:20
Message
#3
|
|
|
Newbie Groupe : Members Messages : 14 Inscrit : 25 oct. 05 Lieu : Lancaster - US Membre no 71,676 |
the cirlce with the triangles is your line-in plug. the one with the headphones is your line-out.
|
|
|
|
|
lun. 10 avril 2006, 12:01
Message
#4
|
|
|
Junior Member Groupe : Members Messages : 178 Inscrit : 14 mars 05 Lieu : - Membre no 62,351 |
PowerBook has only one audio out so to be able to do proper DJ mixing you need a separate audio-interface + a mixing program that's able to route the cue signal to another output.
If you use a splitter in the headphones-out you just end up hearing the same signal in the speakers and headphones. |
|
|
|
|
mar. 11 avril 2006, 00:08
Message
#5
|
|
|
Rookie Groupe : Members Messages : 37 Inscrit : 30 août 03 Lieu : Sydney - AU Membre no 23,835 |
I would reccomend a 1/8 stero jack to rca's cable (get it at an electronics store). run this from your audio out of computer into a channel of a mixing desk, (say a cheap beringer 6 channel desk or even a 2 ch dj desk with crossfaders) then run your monitors out of the main outs of desk. This way you can plug headphones into desk and control the monitors as well.
I sure hope your problems get simpler. This is real basic stuff here. |
|
|
|
|
2 utilisateur(s) sur ce sujet (2 invité(s) et 0 utilisateur(s) anonyme(s))
0 membre(s) :
