MacMusic.org  |  PcMusic.org  |  440Software  |  440Forums.com  |  440Tv  |  Zicos.com  |  AudioLexic.org
Loading... visiteurs connectés
Bienvenue invité
 
Reply to this topicStart new topic
> Hiss On Fw 410, Hiss Problem
uncle_bykel
posté ven. 18 févr. 2005, 05:37
Message #1


Newbie


Groupe : Members
Messages : 3
Inscrit : 18 févr. 05
Lieu : Santa Monica - US
Membre no 60,789




Hi....Can't figure out this one. I have a 1.42g power mac. I use Garageband for voiceover work. I've got an Electrovoice RE-20 plugged into an M-Audio Firewire 410. I almost have to turn the gain up full to get a good voice level. It's neither the cable nor the mic (I've tried other mics too) that's the problem. I've checked them both. Turning the gain up high, causes, of course, a lot of hiss. The 410 is set as my audio in and out in the preferences, but when I run the output through the 410 I have a loud hiss. When I run the audio through the mac, I don't get as much hiss. But I always get hiss from the mic input. What could this be? My audio work demands a clean signal. The hiss is killing me! wink.gif
Go to the top of the page
 
+Quote Post
mpcmaniac
posté ven. 18 févr. 2005, 20:36
Message #2


Newbie


Groupe : Members
Messages : 10
Inscrit : 26 janv. 05
Lieu : Miami - US
Membre no 59,239




Are you running the mic directly into the M audio interface?
If you are you may want to try a pre amp. Check out the Focusrite trakmaster its not that expensive. It will help you bring up your levels and also give you a nice sounding mic.
Go to the top of the page
 
+Quote Post

Reply to this topicStart new topic
2 utilisateur(s) sur ce sujet (2 invité(s) et 0 utilisateur(s) anonyme(s))
0 membre(s) :

 

Version bas débit - jeudi 12 déc. 2024, 19:35
- © MacMusic 1997-2008