Analogue Trance/Goa, in need of synths for it |
|
|
|
ven. 16 janv. 2004, 11:02
|
Rookie
Groupe : Members
Messages : 30
Inscrit : 11 janv. 04
Lieu : Barcelona - ES
Membre no 32,956
|
Hello,
I would like to build a home studio to create trance and psychedelic goa.
I have Powerbook G4 and a hard drive Lacie with nothing else, not even a sequencer.
I'd like to buy "Fat Sound"; I prefer analogue rather than the small digital sound, and i would need your advice.
My idea : an Acces Virus KC or next model, a Sherman Filterbank may be better than Moogerfoogers, a MiniMoog Voyager with the expander module (I don't know if this is usefull for my studio, I haven't seen yet trance artists use this kind of gear).
What would you advice me, to build my studio in a goa psyche spirit?
(I want as less as soft posible, only Sampletank for PT Digi 002 or ESX24 for Logic Platinum, didn't make the choice yet).
Thanks.
Blue
Ce message a été modifié par CatloveX - ven. 16 janv. 2004, 11:19.
|
|
|
|
|
|
Réponse(s)
|
sam. 23 févr. 2008, 06:48
|
Member
Groupe : Members
Messages : 62
Inscrit : 10 juil. 07
Lieu : Brisbane - AU
Membre no 92,865
|
the nord lead is not analogue the only analogue synth you have mentioned is the 303; and since you will probably want to bring the sounds produced into the digital domain at some point and process them further I would recommend Logic studio. Its 'cheap as', now anyway (under $500 US). Also VST's are no-longer supported on mac, AU (Audio Units) are the way to go unless you are planning on buying a pre-intel mac in which case you could use VST Wrapper or similar software to convert vst to AU. So while I support your move to mac I recommend you do your research first so you don't have a whole heap of unusable software.
--------------------
Jeremy Glover graphic designer and compositor extraordinair but a relative novice at audio Mac G5 1.8DP 4gig ram .. RME Hammerfall DSP 9632 .. Behringer ADA8000 adat interface • KRK ROKIT 6 and RP10S•Micro korg Synth/vocoder with RODE NT2-A Logic pro 7 NI kontakt, battery FM8, Altiverb Arturia Moog modular minimoog arp2600.
|
|
|
|
|
sam. 23 févr. 2008, 12:08
|
Newbie
Groupe : Members
Messages : 9
Inscrit : 13 févr. 08
Lieu : Corfu - GR
Membre no 98,815
|
QUOTE (qusp74 @ Sat 23 Feb 2008, 07:48) the nord lead is not analogue the only analogue synth you have mentioned is the 303; and since you will probably want to bring the sounds produced into the digital domain at some point and process them further I would recommend Logic studio. Its 'cheap as', now anyway (under $500 US). Also VST's are no-longer supported on mac, AU (Audio Units) are the way to go unless you are planning on buying a pre-intel mac in which case you could use VST Wrapper or similar software to convert vst to AU. So while I support your move to mac I recommend you do your research first so you don't have a whole heap of unusable software. Very useful advises, I think I'll get Logic. Is there any chance I'm going to find a way about the Nordlead 2? Any suggestions about analog synth? SH 101? This is old but classic. As for Access Virus, it costs a lot. Anyhow I think I'll get a Nordlead. The question is : Will I be able to use it with Logic? thanks!
|
|
|
|
|
sam. 23 févr. 2008, 15:25
|
Member
Groupe : Members
Messages : 62
Inscrit : 10 juil. 07
Lieu : Brisbane - AU
Membre no 92,865
|
just because the nord isn't analogue (Its what they call Virtual Analogue in fact the first nord lead was the first Virtual Analogue synth) doesn't mean its not a great synth; its fantastic; perhaps not as good or as well integrated into the digital domain as all the access gear which has fully integrated plugins that you can add to logic tracks. Still its an axe of a synth and pretty good value for money these days. As for whether it will work with logic; of course it will any midi compliant synth will work with logic all you have to do is connect it to your midi interface and your audio interface and hey presto...well wicked... though to get full functionality you will have to set up the 'environment' in logic to allow access and control of all its parameters via midi. Also; as has been mentioned earlier in this thread you should think about adding some warmth to the signal chain whether it be by using a valve pre-amp or even plugins such as 'AmpFarm' or 'Amplitube' Oh and the SH 101 is great and will give you true analogue kudos but you will have to get some kind of Midi to CV converter to allow you to sequence it. Good luck hope this helps happy warping
Ce message a été modifié par qusp74 - sam. 23 févr. 2008, 15:34.
--------------------
Jeremy Glover graphic designer and compositor extraordinair but a relative novice at audio Mac G5 1.8DP 4gig ram .. RME Hammerfall DSP 9632 .. Behringer ADA8000 adat interface • KRK ROKIT 6 and RP10S•Micro korg Synth/vocoder with RODE NT2-A Logic pro 7 NI kontakt, battery FM8, Altiverb Arturia Moog modular minimoog arp2600.
|
|
|
|
Les messages de ce sujet
CatloveX Analogue Trance/Goa ven. 16 janv. 2004, 11:02 lepetitmartien The Voyager will cost as much as 5-6 "big nam... mar. 20 janv. 2004, 02:55 Eternal Tedium what's your budget? mar. 10 févr. 2004, 08:33 CatloveX The budget is not a problem as I can do it on the ... mar. 10 févr. 2004, 09:35 lepetitmartien Well it's a different quesiton and way OT for ... mar. 10 févr. 2004, 22:57 sir eel logic 6 with synths, 828, and and eventide eclipse... mer. 11 févr. 2004, 02:02 pezagent For analog, try as recommended, anything by Studio... mer. 7 avril 2004, 05:23 CatloveX Thanks a lot for your help.
Cosmic Blue mer. 7 avril 2004, 08:08 editbrain to make goa:
hook your walkman cd player to a 12 ... jeu. 8 avril 2004, 20:49 Kaumbo Hello I am in the same path as CatLoveX so I decid... ven. 22 févr. 2008, 11:44
2 utilisateur(s) sur ce sujet (2 invité(s) et 0 utilisateur(s) anonyme(s))
0 membre(s) :
|
|
|