 M-audio Fw 410 Hotplugging? |
 ven. 20 janv. 2006, 01:01
Message
#1
|
|
 Newbie Groupe : Members Messages : 2 Inscrit : 20 janv. 06 Lieu : Petaluma - US Membre no 75,568  |
Hi, I'm a newcomer here with a question about M-Audio FW 410. M-Audio says you should never hotplug the 410 into your Mac but should power down the computer, plug in the FW 410, turn it on, then turn on the computer. Also, when you're done with the 410 you should pwoer down and then unplug it from the computer FW port.
This seems extreme, and I have some friends who say they don't bother to power down to use the FW 410. How do you guys here use the FW 410? Just plug it in and go? Or do you follow M-Audio's advice? Thanks. |
 |
 
|
 |
Réponse(s)
|
sam. 21 janv. 2006, 13:56
Message
#2
|
|
|
Rookie  Groupe : Members Messages : 32 Inscrit : 01 août 02 Lieu : Mt. Pleasant - US Membre no 6,442 |
yes, that could still cause problems If you want to hot swap, use the wall wart. That way there's no power going through the FW port
|
|
|
|
Les messages de ce sujet
glimmer M-audio Fw 410 Hotplugging? ven. 20 janv. 2006, 01:01
ghess This is a Firewire issue. If you are bus powering ... ven. 20 janv. 2006, 14:08 glimmer Thanks for the response. Yes, I'm bus-powerin... ven. 20 janv. 2006, 17:34 mortalengines I would listen to whatever the manufacturer says s... sam. 21 janv. 2006, 23:58
lepetitmartien And there's been a few horror stories upon fri... dim. 22 janv. 2006, 00:41 |
1 utilisateur(s) sur ce sujet (1 invité(s) et 0 utilisateur(s) anonyme(s))
0 membre(s) :
