MacMusic.org  |  PcMusic.org  |  440Software  |  440Forums.com  |  440Tv  |  Zicos.com  |  AudioLexic.org
Loading... visiteurs connectés
Bienvenue invité
> Anyone Using Finale With A Mac?
blueroom
posté jeu. 31 mars 2005, 04:38
Message #1


Newbie


Groupe : Members
Messages : 2
Inscrit : 30 mars 05
Lieu : Ottawa - CA
Membre no 63,201




I recently purchased a Roland Fantom X6. I use a Mac G5 and have installed Finale 2005. I can't seem to get Finale to send patch changes to the Fantom. When I do the Tutorial in the Finale tutotial book (chapter 6 - more midi topics) the result I get is not correct - the patch assignments are not recognized by the X6 - it plays all the parts with the one sound - whichever sound the X6 has selected on its screen - not affected by the data I have entered in Finale. However, I can enter notes in Finale using the X6 as a midi source so I know the computer and the X6 are sending and receiving the midi signal.

Is anyone at this site using Finale with a Mac? Can you offer any suggestions to get me started?

Any help would be appreciated.

blueroom
Go to the top of the page
 
+Quote Post
 
Start new topic
Réponse(s)
blueroom
posté ven. 1 avril 2005, 03:36
Message #2


Newbie


Groupe : Members
Messages : 2
Inscrit : 30 mars 05
Lieu : Ottawa - CA
Membre no 63,201




Thank you to ghess, MidiMacMan, beltunabob, and leekunkel!

Re beltunabob's suggestion re Finale forum - thanks I didn't know it existed. I have now found it and will check it out.

Re leelunkel's suggestions about turning off "local switch' on the Fantom, I have now tried that and, while the result is different, it's still not correct. i will tinker with this further. Re the OSX midi set up - I thought I had done that properly but will try out your suggestions to set up another devise... sounds more complicated than it should be... but I will go there if nothing else works

Re what both ghess and MidiMacMan said about "open the instrument list...do not change the channels listed..." I'm puzzled. I had assigned each staff its own patch on its own channel (e.g. staff one is "flute", midi channel one, GM 74 Flute, staff two is "Choir", midi channel two, GM 111 Choir Aahs, etc) When you say not to change channels...don't understand - I have to assign each sound its own channel, no?

Re MidiMacMan - appreciate the thoughtful reply - I am going to need more time to try out each of these suggestions. I can relate to the frustrations and gratifications of trying to compose with Midi.

After I have tried all this out I will post news if I achieve success. Thanks all!

blueroom
Go to the top of the page
 
+Quote Post



Reply to this topicStart new topic
3 utilisateur(s) sur ce sujet (3 invité(s) et 0 utilisateur(s) anonyme(s))
0 membre(s) :

 

Version bas débit - samedi 2 nov. 2024, 07:23
- © MacMusic 1997-2008